This is a short extract from our Hall Table Build.
For the context – read below.
I was in the process of cutting tenons, and at this point deliberately aiming at a joint that was too tight.
We would then show the process of truing the fit.
Not to sound obnoxious, but I came in to a problem.
I couldn’t cut a joint wrong.
Once you know how to cut a joint, you know how to cut it.
And after repeating it many times, it just does it right.
It became a little frustrating as the tenons kept fitting straight off the bat, and led me in to a bit of a rant.
The subject… Scruffy Dovetails.
And why I think historically, gappy dovetails were often the outcome of a poor saw, and not necessarily a lack of care, or for speed, as most think today.
Of course this is one of many reasons.
Many a poor joint will have been cut by a jack of all trades replicating what he’s seen, for example.
But in my experience, dovetails are one of the few techniques in woodworking where you really can blame the tool.
A poor saw will cut poor joints. unless you want to spend hours fettling with a chisel.
Please bear in mind that this is just a spewed out Rant. The wording isn’t perhaps precise, but I’m sure you’ll get the gist.
If you haven’t signed up for the Hall Table Build, then there’s still one last chance to get the discount, before the price goes up tomorrow.
Find the details HERE.
And if you’ve joined us already, then go log in… because Chapter One is now live!